H-REAP Design and Deployment Guide – Cisco Learning Read more about controller, lwapp, configuration, wireless, configured and wlans. HReap Design and Deployment Guide: /products_tech_noteashtml Configuring Hybrid REAP. 27, 24, , 2/8/, Wireless LAN IPv6 Client Deployment Guide New! 55, 14, , 6/29/, H-Reap Design and Deployment Guide.
||6 July 2017
|PDF File Size:
|ePub File Size:
||Free* [*Free Regsitration Required]
You would have to manually configure the information on both.
What is H-REAP mode?
Newer Post Older Post Home. Anonymous February 7, at Anonymous July 2, at First, authentication timers on clients; they expect to have authentication complete within a reasonable amount of time, and if not then they will assume it has failed and try to reconnect and start the authentication process over.
Steve Williams June 27, at 7: Why must the latency not exceed 2 seconds v.
Troy Martin June 15, at Here is a link from cisco. Kristjan December 5, at Posted by Andrew von Nagy at 9: Ensure the secondary WLC is in the same mobility group, and ideally configured on each AP in the controller preferences.
Andrew vonNagy March 1, at 6: Andrew vonNagy February 7, at 9: Andrew dwsign June 29, at 8: Andrew vonNagy July 29, at 9: Kristjan, No configuration is replicated between controllers.
Local controller at remote site is primary controller for the APs at remote site and centrally located controller is secondary controller for desiggn APs at remote site. Anonymous November 16, at 9: Hi, It is true that the cisco can supports dynamic vlan assignment with hreap configured in local-switching mode?
Motorola is trying to get their with their WiNG product but will take some time. That way it’s easier to remain nad top of the changes in an incremental fashion, rather than trying to figure out what changed from a year ago and three releases ago: Anonymous November 15, at 6: In this post, I will build on those basic fundamentals and provide more depth on the recommended deployment guidelines if you’re thinking about deploying H-REAP for remote sites.
And we are noticing the loop in to the network? Do we need to all H-reap groups on both controllers even there are no APs on other controller in that group?
What is H-REAP mode?
Cheslin June desgin, at 8: First, several guidelines are recommended for successful deployment. Anonymous March 1, at 1: I have not yet evaluated the Aerohive solution, but have some gear that I will be looking at soon. Hi Andrew, Sorry, I missed that post Hi Andrew Thank you for useful info and I really enjoy reading it.
Andrew vonNagy November 17, at BJ December 24, at 2: It hrwap seem like a refreshing approach, and I am curious to see how their system scales to large environments. This is still an open feature gap. When we initiate fail-over from primary controller local to secondary controller central with ms or more WAN latency AP fail-over works fine hrfap when AP gets associated to central controller the clients connected to the AP gets disconnectes and re-authetication takes place.
Revolution Wi-Fi: H-REAP Deployment Guidelines and Feature Limitations
Andrew vonNagy December 13, at 2: Searching high and low for this but could not still get my hands on one. Same mobility group name is configured on the both controllers and we are following HREAP guidw requirements.
If you continue to run into troubles, you should call Cisco TAC to investigate. Troy Martin June 10, at 5: